simple ignition schematic
02-25-04, 04:14 PM
#1
Senior Member
Thread Starter
Join Date: Nov 2001
Location: Wisconsin
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
simple ignition schematic
This is for my race car. What I have is a 73 rx2 and I am putting a 13bt in it. On the ignition side, I am putting in a modified distributor from my 80 and I was wondering if someone had a simple schematic I could look at that had the key ignition, coils and starter. I need to rewire this thing, but I am getting confused trying to look at wiring diagrams, I want something that is simple so I can wire this puppy up and be done with it. Thanks guys.
02-26-04, 01:00 AM
#2
Get a fog lights relay except the terminals for the lights will hook up to the (+) terminal of the coil. Be sure to use an in-line fuse. For the low voltage (controls the relay) can be a toggle switch OR a line coming from the ignition switch (energized when the key is ON). Usually, the non-bosch kit will give you a diagram.
Now for the igniters, 80 dizzy is a little blurry to me but it has a separate igniter so it should be the same as the 81+. the igniter should have a engraving in back --- that is (+) and (-) terminals. Run a wire from igniter (+) to coil (+). that applies to the (-) as well.
Now for the igniters, 80 dizzy is a little blurry to me but it has a separate igniter so it should be the same as the 81+. the igniter should have a engraving in back --- that is (+) and (-) terminals. Run a wire from igniter (+) to coil (+). that applies to the (-) as well.
Last edited by Siraniko; 02-26-04 at 01:03 AM.
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM
