RX3 3-Link Project
01-11-12, 10:49 AM
#27
Full Member
Join Date: Nov 2011
Location: Indonesia
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Wants to ask about RX3 engine swap with 13BT
I'm David from Indonesia. I'm planning to do the same engine swap as yours. Do you mind telling me what kinds of coil over are you using ? Do you mind sending me photos of yr engine swap about the gearbox position, engine position and etc. If yes, kindly send them to; david_leonardi@yahoo.com
Awaiting for yr reply. Thanks a lot.
11-05-12, 11:31 AM
#29
The General RE
Thread Starter
Here's the Heavy Duty 3rd Link installed.
I went through a few trial designs cut from plywood before I was able to settle on the design I was going to get fabbed up. I used a local trophy truck shop to make my link. They did a great job. Exactly to print and the welds look great. Link is 1.5" OD 0.190" Wall 4130 Chromoly Steel.
I went through a few trial designs cut from plywood before I was able to settle on the design I was going to get fabbed up. I used a local trophy truck shop to make my link. They did a great job. Exactly to print and the welds look great. Link is 1.5" OD 0.190" Wall 4130 Chromoly Steel.
05-22-19, 09:01 PM
#31
Here's the Heavy Duty 3rd Link installed.
I went through a few trial designs cut from plywood before I was able to settle on the design I was going to get fabbed up. I used a local trophy truck shop to make my link. They did a great job. Exactly to print and the welds look great. Link is 1.5" OD 0.190" Wall 4130 Chromoly Steel.
Attachment 692283
I went through a few trial designs cut from plywood before I was able to settle on the design I was going to get fabbed up. I used a local trophy truck shop to make my link. They did a great job. Exactly to print and the welds look great. Link is 1.5" OD 0.190" Wall 4130 Chromoly Steel.
Attachment 692283
05-27-19, 11:44 AM
#32
The General RE
Thread Starter
The following users liked this post:
GucciBravo (07-11-23)
