RX-3 Strut Tower Bars available in 2 days!!!
#1
RX-3 Strut Tower Bars available in 2 days!!!
Well I just picked up and finished welding these puppies for you guys, more will be on the way. The center section tube will be here tomorrow and once those are all welded and powder coated, I'll be putting them permanently on the website. Here's the pictures of those
#7
I actually own Rotaries
iTrader: (40)
will this work if your running a racing beat intake and Holley??
Trending Topics
#8
Not sure,
you will need to grab a rod or stick or anything long and straight. If you lay it across the top of it (right on the towers themselves) if it clears at such, it will clear the bar for sure, the bar actually would sit just a bit higher than 1/4" from there. You can try it through either the forward position (as shown in the picture), or flipped around where it would be closer to the firewall.
you will need to grab a rod or stick or anything long and straight. If you lay it across the top of it (right on the towers themselves) if it clears at such, it will clear the bar for sure, the bar actually would sit just a bit higher than 1/4" from there. You can try it through either the forward position (as shown in the picture), or flipped around where it would be closer to the firewall.
#10
Cheers
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM