does anyone have a pressure plate for sale for a rotary pick up

 

mazda rx4 from 74 to 78 are pretty much the same, have couple of them around the shop, used but good condition.

 

They are NOT the same.

I have a used one kicking around. Its condition is used but could be reused. What condition is yours?

 

let's see 13b 4 port "old school"

 

bump

 

Any pre-83 RX-7 pressure plate will fit. they are all 215mm.

 

REPUs have a different flywheel IIRC.

 

darn i was hoping someone had 1

 

I think I still got it laying around, 76 13b RX4, when I was at the dealer ship I collected lots of good used plates

 

so a 76 rx4 plate will fit ... how much

 

All I know is that I think it fits, see no reson why not and shipping will do

 

how much for shipping

 

Just bring your flywheel to Action Clutch in East LA. Ask for Alex 323/269-2281. Tell him that Romeo sent you.

 

"O" I think I still got the fly wheel, I went to a 86, it's litter

 

"The password is lighter" [/whisper]

 

u guys have a round about priceola

 

I don't spell so good, and for cost cover shipping and you can have both fly wheel and plate, but you know i need to check and make sure they are still inthe pile of part, but if I where you I would be thinking of up gradeing like I did, so much easyer to find parts, O I did have to trim some of the bell housing away on the inside to clear the new plate, once done it went all toghter no problem

 

well isnt 1 a 6 bolt and the other 9 bolt

 

REPU is 9 bolt.

 

I'm thinking, ##############, the RX4 13b has 6 with 3 dow pins which could be pull and threded and all them later ones have 9 with the same pattern for 6+3 and 9 , did I say that rite

 

The '78 RX-4 has 6 bolts and no pins. You're probably thinking a GSL-SE which has 6 bolts and 3 pins.

RX-4 215mm clutch
REPU 225mm clutch with offset
GSL-SE 225mm clutch

 

i needed one for a our rally truck

 

better listen to jeff20b, he knows what he is talking about. You might find that a complete setup from a gsl se is easier to find (flywheel , plate and disc)

 

OK so any how let us know what you are plan on doing, or this post just may get lost in the wind and no help comeing your way