pick up pressure plate
does anyone have a pressure plate for sale for a rotary pick up
|
mazda rx4 from 74 to 78 are pretty much the same, have couple of them around the shop, used but good condition. :cool:
|
They are NOT the same.
I have a used one kicking around. Its condition is used but could be reused. What condition is yours? |
let's see 13b 4 port "old school" :bigthumb:
|
bump
|
Any pre-83 RX-7 pressure plate will fit. they are all 215mm.
|
REPUs have a different flywheel IIRC.
|
darn i was hoping someone had 1
|
I think I still got it laying around, 76 13b RX4, when I was at the dealer ship I collected lots of good used plates
|
so a 76 rx4 plate will fit ... how much
|
All I know is that I think it fits, see no reson why not and shipping will do
|
how much for shipping
|
Just bring your flywheel to Action Clutch in East LA. Ask for Alex 323/269-2281. Tell him that Romeo sent you.
|
"O" I think I still got the fly wheel, I went to a 86, it's litter
|
"The password is lighter" [/whisper]
|
u guys have a round about priceola
|
I don't spell so good, and for cost cover shipping and you can have both fly wheel and plate, but you know i need to check and make sure they are still inthe pile of part, but if I where you I would be thinking of up gradeing like I did, so much easyer to find parts, O I did have to trim some of the bell housing away on the inside to clear the new plate, once done it went all toghter no problem
|
well isnt 1 a 6 bolt and the other 9 bolt
|
REPU is 9 bolt.
|
I'm thinking, ##############, the RX4 13b has 6 with 3 dow pins which could be pull and threded and all them later ones have 9 with the same pattern for 6+3 and 9 , did I say that rite
|
The '78 RX-4 has 6 bolts and no pins. You're probably thinking a GSL-SE which has 6 bolts and 3 pins.
RX-4 215mm clutch REPU 225mm clutch with offset GSL-SE 225mm clutch |
i needed one for a our rally truck
|
better listen to jeff20b, he knows what he is talking about. You might find that a complete setup from a gsl se is easier to find (flywheel , plate and disc)
|
OK so any how let us know what you are plan on doing, or this post just may get lost in the wind and no help comeing your way
|
All times are GMT -5. The time now is 03:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands