My Luce Rotary Coupe RX87
#53
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Last edited by toyo_kogyo; 11-01-08 at 11:37 PM.
#57
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Last edited by toyo_kogyo; 11-03-08 at 02:16 AM.
#68
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
The 13A engine is very rare. It was made exclusively for the front wheel drive Luce Rotary Coupe.
It does share the same rotor width dimentions of the 10A. 60mm
However the 13A rotors are larger in diameter. So rotor housing are larger in diameter. And eccentricity is larger. And low rpm torque is higher than a carby 13B.
#69
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
does anybody know the internal vertical measurement of a mazda rotary housing? As you can see in the above picture's the 13A is 275mm.
Last edited by toyo_kogyo; 11-18-08 at 03:23 AM.
#70
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
I made this short video up today so yall can hear what it sounds like.
The rear muffler has a leak so its a bit louder than its meant to be.
http://www.youtube.com/watch?v=GfkLUMJk44M
#71
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Burleigh Heads Qld Australia
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts