My 73 rx3 work in progress
#152
I actually own Rotaries
Thread Starter
iTrader: (40)
The following users liked this post:
mazdagirl76 (09-25-22)
#153
I actually own Rotaries
Thread Starter
iTrader: (40)
update
finally getting some work done...
The following users liked this post:
mazdagirl76 (09-25-22)
#154
I actually own Rotaries
Thread Starter
iTrader: (40)
a few more
moving right along... the headliner is halfway in... the motor is mated to the 6speed and ready to go in... about half done installing the rubber kit from Scott's... What do you think so far?
The following users liked this post:
mazdagirl76 (09-25-22)
The following users liked this post:
mazdagirl76 (09-25-22)
#159
I actually own Rotaries
Thread Starter
iTrader: (40)
That new cylinder is great!!!! i think it will actually lift the engine when i try... lol
#160
I actually own Rotaries
Thread Starter
iTrader: (40)
motor/tranny went in today. I will try and get some pics later. the 6speed fits pretty tight. i am gonna have to trim my shifter hole about a half inch.... really was not counting on that.
The following users liked this post:
mazdagirl76 (09-25-22)
#162
I actually own Rotaries
Thread Starter
iTrader: (40)
The following users liked this post:
mazdagirl76 (09-25-22)
#165
I actually own Rotaries
Thread Starter
iTrader: (40)
i guess i just love shifting gears i am putting this thing together as fast as i can... i think you should come to NC on a vacation and stay in my garage for about three weeks!!
The following users liked this post:
mazdagirl76 (09-25-22)
#168
I actually own Rotaries
Thread Starter
iTrader: (40)
as promised
lastest pics of the rx3. The engine and 6speed is in... had to cut the tunnel a little but not too bad. the new headliner is in and looking good. what do you guys think?
The following users liked this post:
mazdagirl76 (09-25-22)
#169
I actually own Rotaries
Thread Starter
iTrader: (40)
few more
looking great ot me
The following users liked this post:
mazdagirl76 (09-25-22)
#172
I actually own Rotaries
Thread Starter
iTrader: (40)
It should bolt right up to any, except for top start engines... i would suggest getting rx8 tranny bolts as this trans uses longer bolts than the rx3
thanks bugeye!!! its coming along but i am ready to drive this baby!!!
thanks bugeye!!! its coming along but i am ready to drive this baby!!!
The following users liked this post:
mazdagirl76 (09-25-22)
#174
I actually own Rotaries
Thread Starter
iTrader: (40)
im Always revving the motor and shifting fast
The following users liked this post:
mazdagirl76 (09-25-22)
#175
I actually own Rotaries
Thread Starter
iTrader: (40)
nice tail!!!
just cleaned the tails up and painted them... look pretty good once back in the car
The following users liked this post:
mazdagirl76 (09-25-22)