Have a 74 Rx4 Transmission. Engine is 12A rx7 engine from 83-85 uses a 225mm clutch. The Throw out bearing that came with the clutch kit does not appear to fit nicely with the OG Rx4 clutch fork. I have a brand new N/A clutch fork as seen below. Has anyone messed around with different clutch forks on an rx4 transmission ? the RX7 style clutch fork fits in the hole nice and moves back and forth fine. Looks like the issue is going to be the position of where the slave cylinder rod meets the fork and how far back the fork can go but not sure if that will matter much. Any thoughts or opinions on this are very helpful . Thank you!