Anyone with an RX-3, help me out
#1
Senior Member
Thread Starter
Join Date: Feb 2001
Location: Eats Wetsnatchee, WA
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
Anyone with an RX-3, help me out
What suspension setups are you guys running? Where did you find your parts? I'm going to get the ground control springs up front or chopped rx4 springs and use some 1st gen struts ( i hear that works), hand machined camber plates, front sway bar, and in back I've heard that '96 or so mustang struts work and then get some 2" lowering blocks for the leaves.
Have you guys stumbled across any sites that sell rx-3 parts or do you know about any other funky **** that just happens to work on our cars? I've picked up most of the info from Rotortuner, so I just want to know if anyone else has any ideas.
thanks
steve
Have you guys stumbled across any sites that sell rx-3 parts or do you know about any other funky **** that just happens to work on our cars? I've picked up most of the info from Rotortuner, so I just want to know if anyone else has any ideas.
thanks
steve
#2
Keep to the right.
iTrader: (10)
Join Date: Jul 2001
Location: Mascoutah, IL
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
You may already know this, but King Springs in Australia makes springs for the RX-3...
http://www.kingsprings.com/
Even after paying the huge Australian shipping cost you can get a set of springs for front and back for $320 USD or so...which I guess is reasonable for hard to find parts. If you lived in Australia it would be under $200 USD! Shipping = ouchy.
http://www.kingsprings.com/
Even after paying the huge Australian shipping cost you can get a set of springs for front and back for $320 USD or so...which I guess is reasonable for hard to find parts. If you lived in Australia it would be under $200 USD! Shipping = ouchy.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
LDawg
Old School and Other Rotary
0
08-17-04 04:59 PM