FC/DC

Ok well i am sorting through all my stuff.. taking Old apex seals out and side seals and springs.. all the corner springs are flat and are stuck in carbon and the end peace on the rotor was rubbing on the irons and the end cap looks like its welded on.. is there a way to get these off??? or is the rotor ruined too?

KompressorLOgic

iTrader: (6)

i dont understand?? got any pics?? what end cap??

kettlman

iTrader: (2)

a flat screw drive. put in hole and twist off. i'm assuming you are talking about the round ones right?

FC/DC

yes the dowl lookin things thats on each end of the apex seal. and that runs near the side seals... ill give that screw driver thing a try

No pics i dont have a camara

ddub

Unless I am misunderstanding what you're saying, depending on the extent to which the rotor was rubbing against the iron, as well as screwing with those seal grooves, the rotor may need to be replaced.

All depends on the amount of damage that was done.

WallyHojo

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ This is why I'd like that man to help me rebuild