Power FC help
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2011
Location: Tacoma WA
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Power FC help
Anyone near tacoma that is good with a Power FC or have a datalogit? I have a FD with a atkins street port, single turbo conversion, and pretty much upgraded everything.
Running 850cc primaries, and 1680cc secondaries. I shouldn't say running though because it dies 3 seconds after starting. I need help to get it running so I can atleast drive it to a place to get tuned. I really don't want to tow it.
Running 850cc primaries, and 1680cc secondaries. I shouldn't say running though because it dies 3 seconds after starting. I need help to get it running so I can atleast drive it to a place to get tuned. I really don't want to tow it.
#2
Blah, Blah, blah
iTrader: (13)
Join Date: Feb 2001
Location: Tacoma, WA
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
The stock map should start that. You're running stock injectors and at idle or low rpm the ecu could care less about secondaries/turbos.
Did you change the MAP sensor or the TPS? I'm assuming timing is stock and triple checked...
Post more info and maybe we can help.
Did you change the MAP sensor or the TPS? I'm assuming timing is stock and triple checked...
Post more info and maybe we can help.
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2011
Location: Tacoma WA
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
I was under the impression that 550cc are stock primary, not 850cc. Honestly don't know if map and TPS are stock, I bought it as is and the previous owner didn't have much info either.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM