NEED TO BORROW e11v2 for a few days!!!!!
#1
FD pro licensed driver
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Renton/Bellevue/Seattle WA
Posts: 2,897
Likes: 0
Received 2 Likes
on
2 Posts
NEED TO BORROW e11v2 for a few days!!!!!
IF ANYBODY HAS AN E11V2 they will let me borrow for a few days, PLEASE PM me. I just need to dyno. My unit just died, (the old 1 ohm resisitor popped).
Please PM me if you have one. I need it asap, for the dyno sunday.
Please PM me if you have one. I need it asap, for the dyno sunday.
#2
FD pro licensed driver
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Renton/Bellevue/Seattle WA
Posts: 2,897
Likes: 0
Received 2 Likes
on
2 Posts
Hi guys. I still need this btw. If anybody has an e11v2 or e8 they have laying around and would like to rent out for a week for 100$ or so, please let me know. My haltech unit is being shipped to australia right now, and it would be nice to get the unit tuned before school starts. It turned out to be a bad PDC chip im the older sytle board. Although I knew it wasn't my wiring that caused the problem (as I had over 250+ miles on the ECU) the haltech tech confirmed that it was just a blown chip that used to blow in the older units. Anyways
Thanks
~Tweak
Thanks
~Tweak
#5
FD pro licensed driver
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Renton/Bellevue/Seattle WA
Posts: 2,897
Likes: 0
Received 2 Likes
on
2 Posts
Most definitely, but when were you thinking?? Again this summer? I don't think we have enough time or people to do it. I am going to have to go and get a base like 7 psi tune from someone around here that is competent to do so, and do my 15+ psi tune later with steve.
Trending Topics
#8
FD pro licensed driver
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Renton/Bellevue/Seattle WA
Posts: 2,897
Likes: 0
Received 2 Likes
on
2 Posts
hmmm for me winter would not be a good time to get tuned... I have to drive from Pullman, to yakima, over a pass, just to get to seattle. Rx7 with 300 rwhp, sounds like it would not be fun coming back haha. But lets see the interest. Z-beater, I am going to make a thread getting the next dyno session figured out with steve if thats ok?
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-16-15 09:07 PM