Kerrrrrr BOOOOOOM
CJ
08-03-06, 05:57 PM
#4
Senior Member
Thread Starter
Join Date: Jan 2005
Location: Portland,oregon
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
Will do...I got the motor back this am and it looks...new! Looked new b4 but it looks newer now. Will get it in the car this weekend and wire in the Haltech. Should be fun...never done the Haltech thing b4. Marc (Spyder)is coming out to assist and I am sure that Adam (AFGmoto1978) will be around as well. Good times!
. Trending Topics
08-07-06, 06:08 PM
#8
I'm modifying the throttle body plenum to accept the 85 buick skylark mass air flow sensor that's needed, fab'in up custom intake tubing and making a custom dash panel for his gauges.
If spider shows up Tuesday the car should be running that night. Then tune Thursday.
Well See
If spider shows up Tuesday the car should be running that night. Then tune Thursday.
Well See
08-07-06, 07:22 PM
#9
Originally Posted by afgmoto1978
I'm modifying the throttle body plenum to accept the 85 buick skylark mass air flow sensor that's needed, fab'in up custom intake tubing and making a custom dash panel for his gauges.
If spider shows up Tuesday the car should be running that night. Then tune Thursday.
Well See
If spider shows up Tuesday the car should be running that night. Then tune Thursday.
Well See
08-08-06, 08:47 AM
#12
Full Member
Join Date: Aug 2005
Location: portland.or
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
So Apex do you have to run a higher octane with the fuel mix ? Man I can't wait.
OH went to the site and it say this about passengers " No passengers, other than instructors with paid participants " Man that freaking sucks ,I wanted a ride.Dammit
OH went to the site and it say this about passengers " No passengers, other than instructors with paid participants " Man that freaking sucks ,I wanted a ride.Dammit
08-08-06, 01:14 PM
#13
Senior Member
Thread Starter
Join Date: Jan 2005
Location: Portland,oregon
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
95 octane is key really...I'll run race fuel in with super. Hopefully that will be super enough. No passengers sucks ***! All of the guys at the shop were excited to go also. Hmmmm.
08-08-06, 02:41 PM
#15
Man I look evil in that picture. 
Regular old synthetic oil for the engine and pre-mix in the gas.
Oil injector pump block off plate done and dropped off. Gauge panel tomorrow hopefully.
No passenger deal suck *****, I was hoping to get a few facial expressions from some friends that were going to come. Damn insurance companies.
Regular old synthetic oil for the engine and pre-mix in the gas.
Oil injector pump block off plate done and dropped off. Gauge panel tomorrow hopefully.
No passenger deal suck *****, I was hoping to get a few facial expressions from some friends that were going to come. Damn insurance companies.
08-09-06, 11:35 AM
#19
Full Member
Join Date: Aug 2005
Location: portland.or
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by afgmoto1978
When I left last night the the Haltech wasn't communicating with the laptop.
08-11-06, 11:38 AM
#22
Originally Posted by cartapex
Runs.....jesus...took long enough! Tune today
08-11-06, 02:19 PM
#23
Senior Member
Thread Starter
Join Date: Jan 2005
Location: Portland,oregon
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Blake
So, what was the problem? MAP sensor? Something else? You sounded a bit on edge when you called me yesterday.
08-11-06, 06:03 PM
#24
Originally Posted by cartapex
lolol yes. It's so damn frustrating! Map maybe..unplugged it and it ran..poorly. Went and got a GM map..no good. Put the orig back in..no good. Timing seems all over the place right now. Wanna come out and give a hand?!
I might be able to make it out there this evening, probably after 8 pm.
Thread
Thread Starter
Forum
Replies
Last Post