rx7_FREAKKK

iTrader: (1)

I think i have all the parts ready, Just not sure if they are all good. I have 3mm cut rotors and have 2mm apex seals, besides that, I think im good to go, But i need some more eyes and i just dont trust myself Right now doing this on my own. SO if anyone has some spare time that would be Killer, its just an NA 13b. and i have the kit ready to go. im in Renton near valley Hospital

TOOSHORT_88

iTrader: (15)

U need 3mm seals. Sell ur 2mm to me!

rx7_FREAKKK

iTrader: (1)

well that would work maybe.. Ill have to see. got some 3mm?

TOOSHORT_88

iTrader: (15)

Just get.some 2mm rotors and.ur good

TOOSHORT_88

iTrader: (15)

Post up ur 3mm cut rotors for sale

rx7_FREAKKK

iTrader: (1)

i was thinkin about doing that . i dont need 3mm on an NA.

Nytrate

iTrader: (1)

LS1/T56, Prob Solved

rx7_FREAKKK

iTrader: (1)

Do me a Favor, And dont give me any type of Options. because chances are Im not gona do it. If people want a V8 get a ******* 928 porche

Rotortuner

Do you already have the engine apart? and everything is good and your just looking to put it back together?

CJG

rx7_FREAKKK

iTrader: (1)

well my engine is limping. but works, So i got an eshaft irons and rotors and housings. I need to get 2mm rotors and i think im good to go. Just dont have the equipment to check specs on the irons and housings to make sure they are not to worn to use

Noxi

iTrader: (4)

If you can get your self a set of s5 rotors for better compression there 2 mil

rx7_FREAKKK

iTrader: (1)

they are s5 rotors far as i can tell. i dont think they are cast. i think they are machined