wideband installation help (ignition wire)
08-13-11, 06:34 PM
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: Apr 2011
Location: jacksonville
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
wideband installation help (ignition wire)
Hey guys. I'm having a hard time finding the 12v switch ignitions source for my gauge and sensor for my inovative wiring gauge. I'm looking at the ignition switch (where you put the key in) and there are two blue/black wires going into it...
Either way, I need a 12v ignition switched source. Anybody have ideas? i've looked at some diagrams and searched but haven't been successful yet.
Either way, I need a 12v ignition switched source. Anybody have ideas? i've looked at some diagrams and searched but haven't been successful yet.
08-14-11, 10:00 AM
#3
Nathan - Best 12v switch on your FD (imho) is in the driver side foot well. There are two empty slots at the top of your fuse box. Stick a spade connector in the top right one with a wire connected to it long enough to reach your WB.
Do a search in the 3rd Gen section...there are pictures.
Do a search in the 3rd Gen section...there are pictures.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM
befarrer
Microtech
3
08-22-15 05:52 PM
