RX7Club.com - Mazda RX7 Forum

New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Very quick question!!

Thread Tools
 
Search this Thread
 
Old 01-25-10, 08:20 AM
  #1  
Full Member
Thread Starter
 
altec_fc3s's Avatar
 
Join Date: Jan 2010
Location: SW. MI
Posts: 68
Likes: 0
Received 0 Likes on 0 Posts
Very quick question!!
Will the drive shaft of an NA S4 RX7 bolt up to the turbo transmission/motor? Are the motor mounts the same (plug & play)
altec_fc3s is offline  
Reply Like
Old 01-25-10, 08:29 AM
  #2  
Right near Malloy

iTrader: (28)
 
Pele's Avatar
 
Join Date: Dec 1999
Location: Behind a workbench, repairing FC Electronics.
Posts: 7,835
Received 503 Likes on 341 Posts
No. The output shaft of the turbo transmission is bigger than the NA.
Pele is offline  
Reply Like
Old 01-25-10, 08:59 AM
  #3  
Full Member
Thread Starter
 
altec_fc3s's Avatar
 
Join Date: Jan 2010
Location: SW. MI
Posts: 68
Likes: 0
Received 0 Likes on 0 Posts
So I will need a ECU (w/ harness), motor, tranny, drive shaft, and rear end to do the swap right?
altec_fc3s is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
05-25-21 05:37 AM
SBG GB: Ohlins End of Summer 2015
SakeBomb Garage
SakeBomb Garage
9
05-11-20 10:04 AM
hogged out vs boost prepped (Nikki)
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SBG GB: Ohlins End of Summer 2015
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
Back to Subforum
New Member RX-7 Technical
View Next Unread
1st gen illumination dimmer repair




Advanced Search
Quick Reply: Very quick question!!


Reply Closed Thread Share

All times are GMT -5. The time now is 12:27 AM.