Thinking Of Buying FC Shell and Installing Engine..Any Advice?
05-13-10, 11:34 AM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: May 2010
Location: Dallas, TX
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thinking Of Buying FC Shell and Installing Engine..Any Advice?
Hey guys,
I'm new here and I found a Turbo FC shell for under $800, but it has no engine, transmission or ECU. My question is how hard is it to install an engine and transmission into this car? I have done an engine swap on my car, but it's a FWD car and I don't know if this swap will be much harder.
Any good sites with good prices on JDM motors? I found one site that had a Turbo motor for that FC for about $1500 before shipping. That included...engine, tranmsission, ECU, harness and I also believe it had the intercooler and piping.
Thanks for the help!!!!
I'm new here and I found a Turbo FC shell for under $800, but it has no engine, transmission or ECU. My question is how hard is it to install an engine and transmission into this car? I have done an engine swap on my car, but it's a FWD car and I don't know if this swap will be much harder.
Any good sites with good prices on JDM motors? I found one site that had a Turbo motor for that FC for about $1500 before shipping. That included...engine, tranmsission, ECU, harness and I also believe it had the intercooler and piping.
Thanks for the help!!!!
05-14-10, 10:20 AM
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
If you've done an engine swap before, the installing the engine should not present a problem.
No idea on the j-specs. Check your local regional forum for recommendations.
No idea on the j-specs. Check your local regional forum for recommendations.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
