starting problems
#1
Junior Member
Thread Starter
starting problems
hey hows it going everyone.. i just bought my very first rx7 its an 85 with a 13b. when i got it it had been sitting for about 5 yrs . when i tried starting it only starts when i put starting fluid into the intake but doesnt stay on i changed the spark plugs flushed it and still doesnt stay on .. i will appreciate any help possible..
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
It's unfortunate you tried to start it after sitting for 5 years. You'll need to flush the ENTIRE fuel system, likely replace the fuel pump, have the injectors professionally serviced and cleaned.
Additionally if it sat without proper prep, you may have damaged the engine internally by scraping rust across all the machined surfaces.
While this article deals with 2nd gens primarily, the 13B 1st gen has almost the same EFI system so most applies:
http://www.aaroncake.net/rx-7/unstore.htm
Additionally if it sat without proper prep, you may have damaged the engine internally by scraping rust across all the machined surfaces.
While this article deals with 2nd gens primarily, the 13B 1st gen has almost the same EFI system so most applies:
http://www.aaroncake.net/rx-7/unstore.htm
#3
Junior Member
Thread Starter
yeah the guy before me told me that he had it running but just stopped driving it one day and it became 5 yrs. i did flush the fuel but havent replaced the injecctors or the fuel pump but thanks for the advice ..
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM