snipped 02 sensor.
Thread Starter
Junior Member
Joined: Feb 2013
Posts: 17
Likes: 0
From: Minnesota
snipped 02 sensor.
As i am replacing small parts such as plugs, wires, fuel filter, etc. I get to the o2 sensor and i found that it was snipped! So what i'm getting to is once i replace my o2 sensor, where do i connect the wire from the 02 sensor? Help? Please? (pictures are nice)
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
..and since the other members have not quite mastered their Psychic abilities you should be stating WHICH CAR you have!,as stated in this Convenient bit of info at the Top of this Section.
https://www.rx7club.com/new-member-r...swers-1030345/
https://www.rx7club.com/new-member-r...swers-1030345/
many aftermarket universal sensors do not come with a connector, you have to cut off the old connector and crimp or solder it to the new bare wire off the new sensor.
IF you don't have it, a female/male spade connector will also work. just avoid crimping any portion of the shielded wire braids to the connector since they are grounded near the ECU and will kill the O2 sensor signal.
IF you don't have it, a female/male spade connector will also work. just avoid crimping any portion of the shielded wire braids to the connector since they are grounded near the ECU and will kill the O2 sensor signal.
Last edited by RotaryEvolution; May 17, 2013 at 05:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
Sep 28, 2015 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
Sep 24, 2015 10:57 PM