single turbo
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jan 2009
Location: lancaster,pa
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
single turbo
hello i have a 1994 mazda rx7 and i just finish my single turbo setup.my question is what do you guys do with the extra vacuum hoses?is there cap kit just for that and if there is where can i buy it?for right know i just put some screws and clamp it down on the extra vacuum lines but i dont like doing that cause it rob some peformance and it looks unprofesional.
#3
When I finshed mine I think I only had one vacuum fitting that needed caping.
I assume you did away with the solenoids.
The group at the middle part of the UIM are only going from one side to the other and does not need caping.
You should be able to get caps at Mazda. If they do not find the part number for RX7 ask them to pull up parts diagram for another car most cars have at least one.
Price chould be around $ 2-3.
I assume you did away with the solenoids.
The group at the middle part of the UIM are only going from one side to the other and does not need caping.
You should be able to get caps at Mazda. If they do not find the part number for RX7 ask them to pull up parts diagram for another car most cars have at least one.
Price chould be around $ 2-3.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
5
01-11-16 04:08 PM
stickmantijuana
Single Turbo RX-7's
0
08-21-15 08:35 PM