S4 & S5 Flywheel Diameter
#1
Junior Member
Thread Starter
Join Date: Jan 2010
Location: Indiana
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
S4 & S5 Flywheel Diameter
Hi All,
I'm looking for the outer diameter of the ring gear on S4 & S5 flywheel. NonTurbo, NA. I'm making plans to mate the tranny to a KL-DE. Just trying to see how different the RX7 diameter is compared to the KL-DE. I know the RX7 has 116 teeth as opposed to the 112 of the KL-DE.
Thanks in advance,
Ron
I'm looking for the outer diameter of the ring gear on S4 & S5 flywheel. NonTurbo, NA. I'm making plans to mate the tranny to a KL-DE. Just trying to see how different the RX7 diameter is compared to the KL-DE. I know the RX7 has 116 teeth as opposed to the 112 of the KL-DE.
Thanks in advance,
Ron
#3
Junior Member
Thread Starter
Join Date: Jan 2010
Location: Indiana
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply! I was thinking that 225 was the O.D. of the clutch. Is the 225mm the diameter of the ring gear? I was hoping the ring gear diameter was in the 290mm range.
#4
Top Down, Boost Up
iTrader: (7)
I'm fairly sure 225mm is the OD of the center section that attaches to the pressure plate. If you measured from the tips of the teeth on the ring gear, it would be somewhere around 20-30mm wider.
Now if you went with a TII transmission, the matching flywheel would be 250mm + 20-30mm or so for the gear.
Now if you went with a TII transmission, the matching flywheel would be 250mm + 20-30mm or so for the gear.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
pfsantos
2nd Generation Specific (1986-1992)
1
09-30-15 01:29 PM