RX7 turn signal problems
#1
Junior Member
Thread Starter
Join Date: Dec 2011
Location: Esco
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RX7 turn signal problems
So my Rx7 right turn signal doesnt work checked fuses they all work switched out the switch nothing anybody know how to see what the problem is
#6
Moderator
iTrader: (1)
Besides the bulbs, when the signal lever is pressed upward for the right turn indicators to work the Green/Yellow wire at the CPU's largest plug should have 12 volts w/key to on. The Green/White wire in the same plug should also have 12 volts w/key to on. If the G/Y has proper voltage, which indicates the turn signal is working properly, but the G/W doesn't have voltage then the contact on the circuit board likely needs resoldering (this is the place where the wire makes contact w/the board at the terminal and the terminal probably has a bad connection to the circuit board thus requiring it to be resoldered).
#7
Junior Member
Thread Starter
Join Date: Dec 2011
Location: Esco
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Besides the bulbs, when the signal lever is pressed upward for the right turn indicators to work the Green/Yellow wire at the CPU's largest plug should have 12 volts w/key to on. The Green/White wire in the same plug should also have 12 volts w/key to on. If the G/Y has proper voltage, which indicates the turn signal is working properly, but the G/W doesn't have voltage then the contact on the circuit board likely needs resoldering (this is the place where the wire makes contact w/the board at the terminal and the terminal probably has a bad connection to the circuit board thus requiring it to be resoldered).
Trending Topics
#8
Junior Member
CPU ain't to cheap. And soldering really isn't difficult. There are a few VERY good how to solder videos on youtube as well. It could potentially save you a few hundred.
#9
Can Post Only in New Member Section
Join Date: Oct 2012
Location: washington
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
I was going crazy trying to figure out why my turn signals won't work. Joined this forum and read about re soldering the contacts on the CPU. It was a little difficult getting it out, and a cinch to put back in. Worked like a charm. No cost to repair, can't hurt to try....
#10
Can Post Only in New Member Section
Join Date: Mar 2019
Location: SC
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Still turn signal trouble
Besides the bulbs, when the signal lever is pressed upward for the right turn indicators to work the Green/Yellow wire at the CPU's largest plug should have 12 volts w/key to on. The Green/White wire in the same plug should also have 12 volts w/key to on. If the G/Y has proper voltage, which indicates the turn signal is working properly, but the G/W doesn't have voltage then the contact on the circuit board likely needs resoldering (this is the place where the wire makes contact w/the board at the terminal and the terminal probably has a bad connection to the circuit board thus requiring it to be resoldered).
I resoldered the CUP before and after this test. Same results. Any more ideas?