New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

rx7 s5 Ideas needed!

Thread Tools
 
Search this Thread
 
Old 12-08-09, 06:24 PM
  #1  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
rx7 s5 Ideas needed!

I'm have what seems to be the same issue. last week i went out to my fc and it started right up like any other normal day, but then it randomly killed after backing out of the driveway. it hasnt started sense. It's getting spark, it has compression, and it gets fuel. iv replaced the fuel pump (walbro 255), fuel filter, and I'm about to switch out injectors. the motor just turns over, but doesnt want to run on its own. I'm running out of ideas :/ I dont run synthetic! (gtx 20w-50 and never had a problem with it in years.)

Last edited by BennybamFC; 12-08-09 at 06:31 PM.
Old 12-08-09, 07:26 PM
  #2  
Junior Member
 
zixxer636's Avatar
 
Join Date: Jan 2008
Location: Ohio
Posts: 7
Likes: 0
Received 0 Likes on 0 Posts
is there gas in it? I had a prob once like this and my intake pipe had slipped off bc clamp came loose. Looked attatched by sight but wasnt if you felt around there.
Old 12-09-09, 09:11 AM
  #3  
tweek

 
tweek's Avatar
 
Join Date: Dec 2003
Location: Va
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
bennybamfc.... injector seals might have gone bad
Old 12-09-09, 02:41 PM
  #4  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
okay... im switching out the injectors today anyway. ill go grab some fresh ones and let ya know how it turns out
Old 12-10-09, 12:27 AM
  #5  
Junior Member
 
badpescado's Avatar
 
Join Date: May 2008
Location: Huntington Beach
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
don't forget to check your timing too? if you're getting fuel, spark, and have compression, then it should start? hey just a thought, you can try spraying some starter fluid in the throttle body too? i was also told that wd4o works for this too?
Old 12-11-09, 10:58 AM
  #6  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
so whats an easy way to check my timing... should i just turn the crack sensor?
Old 12-11-09, 12:44 PM
  #7  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Well everyone... have oil in my coolant lines that go through the throttle body. im pretty sure there was way more water than coolant in my radiator. one of my plates must have cracked :/
Old 12-15-09, 12:47 AM
  #8  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Great news everyone! after ripping all my intake manifolds off, then throwing it all back together while cleaning everything i felt like clean along the way. i got my rx7 to start today. it revs through the RPMs nicely and drove fine, it doesnt like to idle. with my foot off the gas, it'll drop to idle, sit for a few seconds, then kill. Plus it has a hard time starting still. i dont feel i've fix my problem. it use to start up with ease. any ideas? im gunna try timing it tomorrow.
Old 12-15-09, 10:36 AM
  #9  
85' fun lil project
 
jimbowatson2002's Avatar
 
Join Date: Nov 2009
Location: WA
Posts: 51
Likes: 0
Received 1 Like on 1 Post
hmmmmm

it realy sounds like a fuel filter problem or maybe water in the gas.... try to add some (stable) fuel treatment. but if itll run with ur foot on the gas and not idle its getting spark so its not electrical i think its either a filter or maybe a vacuum. have u checked the vacum lines
Old 12-15-09, 12:47 PM
  #10  
Junior Member
 
johnny O's Avatar
 
Join Date: Dec 2009
Location: Bethlehem, Ga
Posts: 23
Likes: 0
Received 0 Likes on 0 Posts
If the pump doesn't supply adequate pressure the injector will stream fuel instead of mist fuel, If the fuel isn't vapor, but liquid, it will NOT ignite even with spark. "noid light an injector to verify pulse also. Fuel pressure check with guage after filter might give a clue which way to go next too."O"
Old 12-15-09, 02:18 PM
  #11  
tweek

 
tweek's Avatar
 
Join Date: Dec 2003
Location: Va
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
did u try re-adjust the idling screw on the throttle manifold after u re-installed it?? Is this car a turbo... if so u could check to see if the intercooler lines are clamped or cracked.. and the vacum lines.. tps could also be ur problem
Old 12-17-09, 05:43 PM
  #12  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
More rx7 s5 Ideas needed!

Okay, this is more of an update to some other postings I've left. A couple weeks ago my rx7 randomly shut off on me after backing out of the driveway. It didnt start for a week and i could figure out why. well a few days ago i got it to start. it didnt start right up like it use to tho. i had a friend jumping me and still it fought to run on its own. When it did run, it rev smoothly through the RPMs and drove strong, BUT it would try to kill at idle if i didnt keep giving it at least a little bit of gas. I could shut it off and start it bad up after it was wormed up, but again, not with ease. I've been checked every vacuum hose, connector, and plug. everything seems fine. I've even put a new fuel filter, fuel pump, and gone so far as to rip apart the intake to clean the injectors and check for leaks. I was gunna time it, but i havent been able to get it start again to do it. Im out of ideas guys. help... please.

Last edited by mar3; 12-17-09 at 05:49 PM. Reason: chgd title, pulld hijacks into OP's "new" thread on same subject in same board...
Old 12-17-09, 06:38 PM
  #13  
tweek

 
tweek's Avatar
 
Join Date: Dec 2003
Location: Va
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
1.low fuel presure.. ive had two walbros fail within a month.. mite wanna check the fuel pressure
2.throttle position sensor might be bad
3.air flow meter
4.pressure sensor
5.clogged injectors...may need cleaning
6.low compression
7.crank angle sensor.. timing may be off
8.ecu
9.air control valve
thats mostly all i can think of rite now..
Old 12-17-09, 06:39 PM
  #14  
tweek

 
tweek's Avatar
 
Join Date: Dec 2003
Location: Va
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
stopped up exhaust..
Old 12-17-09, 07:48 PM
  #15  
Mr. Rotary Power
Thread Starter
 
BennybamFC's Avatar
 
Join Date: Feb 2009
Location: Minnesota
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Thank you everyone for the help i guess my car just need a vacation. just went out to start it... SOB started right up... drives like normal too. I'll let you know if things change.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
LMBTG
New Member RX-7 Technical
7
08-15-15 01:43 PM



Quick Reply: rx7 s5 Ideas needed!



All times are GMT -5. The time now is 08:39 PM.