Rx7 fc the e shaft won't turn with a wrench on a e shaft bolt
02-19-18, 01:45 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Serbia
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Rx7 fc the e shaft won't turn with a wrench on a e shaft bolt
Hi i am new here, my english is not so good sorry about that. i have a problem, my rx7 fc wont turn on e shaft. Transmission is in neutral, i tried both ways but nothing. What can couse this? thanks
02-19-18, 06:19 PM
#2
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Serbia
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
i forgot. I rebuild the engine, start it up. Engine work about 30min, oil pressure good, temp normal but sudenly engine stop working. After that engin wont turn over
02-19-18, 07:36 PM
#3
rotorhole
usually something like this is due to a oil pump key the isnt set properly and winds up in the oil pan, the oil pump then works loose and spins freely, dropping oil pressure while you don't notice and...... chnnnk.
02-19-18, 07:53 PM
#4
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Serbia
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
But the oil pressure was good and i take off front cover to look oil pump. Oil pump was good and the key was there.
Thread
Thread Starter
Forum
Replies
Last Post
RoninRX7
2nd Generation Specific (1986-1992)
13
02-07-08 11:37 PM
CarzArKoo1
2nd Generation Specific (1986-1992)
10
03-29-07 09:14 PM
Manntis
1st Generation Specific (1979-1985)
4
07-05-02 06:54 AM