Rx7 2+2 conversion of 1988 s4
#1
Junior Member
Thread Starter
Join Date: Feb 2010
Location: Oakland, Ca
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Rx7 2+2 conversion of 1988 s4
Hello everyone, new to this forum and i had a few questions about doing this. i have a friend with rear seats to an rx7 and i am about to buy an s4 that did not come stock with rear seats. how would i go about putting the rear seats in? if anybody has a tutorial that would be good
#2
i dont have a tutorial but its dirt easy.
you literally take the carpet and storage bins out, and the rear seats go right where the bins used to go.
i never installed them before but i just took a set out of seats out on an rx7 and it was that easy to take them out. i'm not sure if the holes are pre drilled for the seat belts or not but there should be (im guessing) dimples or something to show where you would drill.
i hope this helps.
you literally take the carpet and storage bins out, and the rear seats go right where the bins used to go.
i never installed them before but i just took a set out of seats out on an rx7 and it was that easy to take them out. i'm not sure if the holes are pre drilled for the seat belts or not but there should be (im guessing) dimples or something to show where you would drill.
i hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM