New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Rough ride and can't pull codes

Thread Tools
 
Search this Thread
 
Old Apr 23, 2015 | 05:23 PM
  #1  
gmadrag's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2015
Posts: 7
Likes: 0
From: Maine
Rough ride and can't pull codes

I went to read my codes but the cel wasn't on. I drove it and in first it was totally fine in the beginning went into second and started to bog then the cel came on. I turned around and then in first or second it would bog down didn't matter either way. I limped back down the road back to the house popped the hood to read the codes hooked up my jumper wire turned on the ignition and once again no blink. Started it back up and no cel again. It only seems to come on after you actually drive it but once you shut it down and restart I get nothing. I can let it idle fine all day rev it up and be fine. Any ideas?
Reply
Old Apr 23, 2015 | 06:03 PM
  #2  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 16
From: tulsa,ok.
And you're grounding the Orange wire in the Green check connector and then turning the key to on?
Reply
Old Apr 23, 2015 | 06:26 PM
  #3  
gmadrag's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2015
Posts: 7
Likes: 0
From: Maine
Originally Posted by satch
And you're grounding the Orange wire in the Green check connector and then turning the key to on?
Yes but once I shut the car off it is like the codes erase so when I turn the key on it doesn't come back on.

Last edited by gmadrag; Apr 23, 2015 at 06:28 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
9
May 11, 2020 10:04 AM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
ZacMan
Build Threads
4
Sep 19, 2015 09:20 PM




All times are GMT -5. The time now is 08:45 PM.