To start off I just bout 18x8.5 with a +45 offset... It was a deal that if I didn't grab it right there another guy was looking to buy them so I went ahead and grabbed them. Unfortunately that meant I didn't think about the offset... stupid.

I have access to a fender roller and dont mind pushing my front and rear fenders out/up since it's going in for paint next month. My question is what will I have to do to modify it to fit my vehicle. If my calculations are right I need to use a spacer with approximately 13mm which means I'll have to restud the hubs is that correct? If it's not a good buy I can always flip them for a profit but they're definitely one of the nicest sets I've ever seen and want to try and use them if it's possible.

 

hub spacers with studs attached.they make them..
Don't you wish you had done research now?..
It's true like credit cards,.buy NOW pay Later!

 

yes.. lol I looked up if anyone was running them but... guess what? they make them in a plus +30 version go figure. I'm going to go up to a rim shop and see if they'll give me crdit towards a new set and if not I'll either resell or buy spacers. stupid, stupid, stupid.