Power Steering Pressure Sensor
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Jun 2013
Location: Florida
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Power Steering Pressure Sensor
I bought a Series 5 FC a couple months ago, coolant seals were blown, needed a rebuild. When I removed the engine, I noticed there was no connector on the end of the power steering pressure sensor. I drove the car a few times, and it seemed "ok". Can I wait to replace this, or is this something I need to fix asap? I've looked and I can't seem to find much information on this other than it increases your idle when turning the wheel while driving slowly to compensate for the effort the P/S pump is putting in.
If I'm correct on this I think it can wait just wait to be sure.
If I'm correct on this I think it can wait just wait to be sure.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
stickmantijuana
20B Forum
8
08-18-15 02:46 PM