New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Now what?

Thread Tools
 
Search this Thread
 
Old Apr 14, 2009 | 09:48 AM
  #1  
dustyaffair's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2008
Posts: 5
Likes: 0
From: Bloomfield, NM
Now what?

Own a 1984 with a 12a engine. California model. Recently replaced stock exhaust with two inch pipe and a turbo on the end. Was told it would increase mileage and horsepower. Cut the Catalyst Thermo Sensor wires and stripped and twisted together. Just pulled the air tube from the converter to the air pump off. The car ran fine for four days but now has developed a problem when you stand on it. Seems to run good thru first and second gear but when you go into third, above fifty MPH, it hits a wall like it has a rev-limiter and doesn't want to tach up any more than four grand or so. Back off and seems to run fair at lower RPMs. Can anyone tell me what I need to do to fix the problem???? Besides put the stock exhaust back on.
Reply
Old Apr 15, 2009 | 11:05 AM
  #2  
Armed_&_Awol's Avatar
Junior Member
 
Joined: Nov 2008
Posts: 10
Likes: 0
From: MN
did you plug that line? search for air pump removal, you will probably have to remove the rats nest to then, not sure
Reply
Old Apr 17, 2009 | 05:12 PM
  #3  
dustyaffair's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2008
Posts: 5
Likes: 0
From: Bloomfield, NM
haven't done aything else. Thanks for the heads-up
Reply




All times are GMT -5. The time now is 03:39 AM.