non power to power doors
#1
Rotary Enthusiast
Thread Starter
iTrader: (14)
Join Date: Mar 2009
Location: the dalles
Posts: 1,161
Likes: 0
Received 0 Likes
on
0 Posts
non power to power doors
not sure how hard it is to swap this. i picked up a nice set of white 86 gxl doors the other day. the only issue i have is that my 87 does not have power doors. now i did notice that when i took my door panels off that i noticed that there was wires already ran, not sure if they are for the p/w or not, im pretty sure they are. but would this be a simple swap? like almost a plug and play? it would be sweet to have the power windows set up easily. the only down side i can think of for this would be havint 2 white doors on my red 7 lmao./♦
Trending Topics
#9
Rotary Enthusiast
Thread Starter
iTrader: (14)
Join Date: Mar 2009
Location: the dalles
Posts: 1,161
Likes: 0
Received 0 Likes
on
0 Posts
ok started this switch today but came into a road bump. when looking inside the car to try and figure out where the p/w plug was hidden i became stumped. couldnt find it anywhere. i tried lookin everywhere.
here is the 2 plugs on my new door.
i can only find where the one on the left goes since its already plugged in. where can i find the bigger one on the right inside the car so i can make my windows work?
here is the 2 plugs on my new door.
i can only find where the one on the left goes since its already plugged in. where can i find the bigger one on the right inside the car so i can make my windows work?
#15
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Most of the time the harness is already in the doors. I have seen a few where it isn't. All you need to do is install the harness if it is not there, or plug the stuff into it if it is.