Newbie to Rotary
#1
Junior Member
Thread Starter
Join Date: Jan 2012
Location: Illinois
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Newbie to Rotary
So this is my first attempt at a Rotary. I have a 83 RX7 Shell no engine no trans no Driveshaft. So I'm picking up a 88 13B FI with Trans. Will that all fit in there? I'm going to be taking off the FI for a CARB Setup I want to learn Carbs never done that neither all of my cars have been FI.
Any help would be greatly appreciated here. I'll have Pics this weekend.
Lem
Any help would be greatly appreciated here. I'll have Pics this weekend.
Lem
#2
10/6
iTrader: (15)
This is a very open question....Someone will need to give you alot of info.
To make this short, the answer is yes it can be done....You need a front cover from a first gen or a old school RX. Engine mounts are in different 1st gen vs 2nd gen.
Here is some info from the 1st Generation Specific (1979-1985) section---sticky
https://www.rx7club.com/1st-generation-specific-1979-1985-18/1st-gen-rx-7-faq-page-237777/
This is a kinda beat to death question... people will help you, but it helps if you have a good idea about the parts.
The FAQ is a good starting point.
Where are you in IL?
To make this short, the answer is yes it can be done....You need a front cover from a first gen or a old school RX. Engine mounts are in different 1st gen vs 2nd gen.
Here is some info from the 1st Generation Specific (1979-1985) section---sticky
https://www.rx7club.com/1st-generation-specific-1979-1985-18/1st-gen-rx-7-faq-page-237777/
This is a kinda beat to death question... people will help you, but it helps if you have a good idea about the parts.
The FAQ is a good starting point.
Where are you in IL?
Thread
Thread Starter
Forum
Replies
Last Post
datfast1
Old School and Other Rotary
18
06-20-19 10:53 PM
Under PSI
3rd Generation Specific (1993-2002)
19
09-23-15 11:47 PM