need pin out for 13b
10-14-11, 12:20 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2011
Location: Inverness,Fl
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
need pin out for 13b
i am going to be wiring my 13b i recently droped into 1980 corolla in need of a pin out for the ecu so i know what goes where thanks
10-14-11, 01:00 PM
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
13Bs were available since about 1974 until present (the Renesis is technically a 13B). So you're going to have to be more specific about what type of car your 13B came out of. But to get you started, http://foxed.ca/foxed/index.php?page=rx7manual
10-16-11, 10:12 AM
#4
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
See the link I gave you for the factory service manual. It contains wiring diagrams.
The Haynes wiring diagrams are also good enough to do this. It's actually pretty easy to modify the harness to run independently of the car.
The Haynes wiring diagrams are also good enough to do this. It's actually pretty easy to modify the harness to run independently of the car.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
