Help needed
Thread Starter
Newbie
Joined: Nov 2019
Posts: 2
Likes: 0
From: Hamilton
Help needed
Hi new to the rotary seen been going through forum to find some advice but cant seem to find the answers.
just brought a brand new fd 13b block from mazda.
Putting it in a 1976 mazda b1600
Will be running after market ecu and borg Warner 300 single turbo aiming for 400hp
Have mounted using a brand new 12a turbo front cover.
1)just wondering what omp i need to use dont want to run premix
2)what cas do i need to use
3) what water pump do i need to run
4) have early front bowl sump but need oil level sensor any idea on which one i need to buy?
just brought a brand new fd 13b block from mazda.
Putting it in a 1976 mazda b1600
Will be running after market ecu and borg Warner 300 single turbo aiming for 400hp
Have mounted using a brand new 12a turbo front cover.
1)just wondering what omp i need to use dont want to run premix
2)what cas do i need to use
3) what water pump do i need to run
4) have early front bowl sump but need oil level sensor any idea on which one i need to buy?
I'm not familiar with the OMP of the 12A turbo to know if it will work with the FD. The FD needs 4 lines.
A 1984/1985 GSL-SE 13B OMP might work. I'm not sure about the compatibility between the 12A turbo and GSL-SE front cover.
A 1984/1985 GSL-SE 13B OMP might work. I'm not sure about the compatibility between the 12A turbo and GSL-SE front cover.
Thread
Thread Starter
Forum
Replies
Last Post