New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Help identifying parts

Thread Tools
 
Search this Thread
 
Old Sep 17, 2021 | 12:49 AM
  #1  
Dreaded_doobie's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2021
Posts: 5
Likes: 0
From: PNW
Help identifying parts

So my story is in the introduction subforum, but basically I found a SA FB at a garage sale that was an old track car. It seems to be heavily modified and would like some help identifying parts.
So far I've found that it's on Tokico Blues all around, has a Racing Beat strut tower bar and radiator shroud, and has a weber carb with an "Australian" style intake manifold. My throttle cable actually goes over the plate rather than under with my fuel inlet facing towards the engine.

I haven't found out which fuel pump it has. I've pulled it, but I could find no markings on it. I'll include some pictures. It looks a lot like a Holley, but I can't tell if it's blue or red.

No markings

Another angle


As a bonus, my cable that mounts in a weird way. It used to be held in with checken wire by the PO.

Putting Unifilters on the Weber since the hood wouldn't close with the K&N the PO put on. The car would get battered by the wind on the highway!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Maxwedge
Build Threads
17
Apr 15, 2019 01:04 PM
UnregisteredSA22C
1st Gen General Discussion
5
Oct 24, 2016 11:46 AM
OneRotor
1st Generation Specific (1979-1985)
2
Oct 19, 2011 06:39 PM




All times are GMT -5. The time now is 09:37 PM.