pulled a hose off when I replaced the slave cylinder..can any one tell me where it goes big help if ya could it's the hose just above the oil filter.

 

I must be blind but everything looks attached

 

same here too.
I'd venture a guess and say that it would come off the engine where there is a hose NOT connected!

 

yah it's just laying behind the intake manifold I'll take anothe pic here in a few

 

I found the spot..but thanks for the replying..i do have another question. the 7 runs good when you first start it up, but it takes a while, then after it has been running for about 10 to 15 min the oil pressure starts to drop then it starts idling down till it finally cuts off but you can start it right back up and it will idle fine then slowly idle itself back down. also it has Ben sitting for about 7 years. O and be for I forget it smells like I'm burning leaves after I've run it for awhile..any help thanks.

 

You'd be surprised at what can make a home in your engine bay in that 7 years.