Heater not working in my '87
#1
Junior Member
Thread Starter
Heater not working in my '87
Hey my heater in my '87 isnt working. Ive looked into it a little bit and noticed the vavles arent even opening. Anyone else have this problem? Help PLEASEE IM FREAZING TO DEATH!!
#2
Hoodrat Slayer
Join Date: Oct 2011
Location: Virginia
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
service manual. check to see if the lines are routed correct. Also, there is a valve that controls if the coolant flows through the heatercore in the engine bay. check if it is open.
#3
Theoretical Tinkerer
iTrader: (41)
^The valve is inside the car and attached to the air mix motor.
When you switch the temp comtrol to warm, do you hear the air mix motor moving the flapper inside the console? If so, you probably have a clogged heater core. If not, you have a bad logicon/air mix motor. In the mean time, unhook the air mix motor from the flapper door and move it manually. You can just leave it on hot until about March, then figure out what to do with it.
When you switch the temp comtrol to warm, do you hear the air mix motor moving the flapper inside the console? If so, you probably have a clogged heater core. If not, you have a bad logicon/air mix motor. In the mean time, unhook the air mix motor from the flapper door and move it manually. You can just leave it on hot until about March, then figure out what to do with it.
#4
i am having a problem similar to this. my heater, seems to blow about 80% of the air to my feet, no matter what setting i have it on, however it does blow hot... very hot. i have a manual, but i dont know where to start. does anyone have an idea?
Thread
Thread Starter
Forum
Replies
Last Post
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM
KAL797
Test Area 51
0
08-11-15 03:47 PM