Hey,

So MY89' T2 is spewing out fuel from the injectors. Luckily I caught it before I drove out.

I believe the rubber part is torn on the injectors.

How hard is it to remove the manifold? I tried searching on here and I didn't really find anything on it.

Anyone with experience can guide me through this?

Thanks in advance!

 

A Haynes manual and the FSM (see 2nd gen FAQ) will be required.

Injector o-rings and rubber grommets are available through Mazda dealerships or Mazdatrix. You should buy a full set for all 4 injectors. Per injector, there will be an upper and lower grommet & an o-ring.

You will also need to buy a LIM/UIM gasket and I'd also suggest the hose connecting the rear iron to the thermowax. This one is easiest to just cut off, then replace. It's a serious pain to reach.

 

Yea, I replaced the O-Rings!