New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Failed Smog due to NO (PPM)

Thread Tools
 
Search this Thread
 
Old Aug 14, 2014 | 09:49 PM
  #1  
LT 562's Avatar
Thread Starter
Full Member
Tenured Member: 15 Years
Liked
 
Joined: Dec 2010
Posts: 52
Likes: 1
From: SoCal
Failed Smog due to NO (PPM)

Just bought the car (1995 Rx7), I will put some time into a proper introduction in the new members forum asap.

Tried to Smog the car today and it failed with a 15mph NO measure of 1017 PPM vs 704 PPM Max. Tech speculates it could be a faulty o2 sensor causing car to run lean.

Records show the car got a full tune up at Tri-Point Engineering in 12/11 with 78,348 miles which included plugs and o2 sensor followed by a Smog Pass. Back then it measured 670 PPM at 15mph.

Today, almost 3 years later but with only 300 additional miles it's a very different story. Can the o2 sensor fail after so few miles but that long just sitting around? Looks like an expensive unit that was used at tune-up.

I'm about to buy an NGK unit for like $25 but thought I'd check with the brain trust here before placing the order.

Thanks much.

L T
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
NickNac113
1st Generation Specific (1979-1985)
13
Oct 1, 2015 09:25 PM
Zinraf
2nd Generation Specific (1986-1992)
3
Oct 1, 2015 01:09 PM
Smokeyfb33
Old School and Other Rotary
10
Oct 1, 2015 12:10 PM
pfsantos
2nd Generation Specific (1986-1992)
1
Sep 30, 2015 01:29 PM




All times are GMT -5. The time now is 02:04 PM.