Engine swap 13B-12A!
03-13-09, 03:45 PM
#1
Engine swap 13B-12A!
I bought a 85' GS and it came with a 13b 6 port but it blown a seal so I swaped the 13B to its original 12A. the braket that goes on the motor mount I turn it around so it would fit the 12A, is that ok or I better change it?
04-04-09, 09:34 PM
#5
I need a new user title
Join Date: Oct 2005
Location: Yaizu, Japan
Posts: 2,646
Likes: 0
Received 0 Likes
on
0 Posts
How was the 13B installed? Did they use an RB front mount bar or a GSL-SE crossmember?
If it's the former, you can just grab any stock mount bar and it'll work.
If the latter, you'll need a 12A crossmember and you can keep the mount bar you already have. Or you can do what I did: long studs on the front cover and some aluminum spacers.
If it's the former, you can just grab any stock mount bar and it'll work.
If the latter, you'll need a 12A crossmember and you can keep the mount bar you already have. Or you can do what I did: long studs on the front cover and some aluminum spacers.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM
maikelc
3rd Generation Specific (1993-2002)
8
08-24-15 11:04 AM
