Easy way to lubricate Engine Rotors on a stored FD ?
Thread Starter
Newbie
Joined: Apr 2012
Posts: 0
Likes: 0
From: Davenport , FL
Easy way to lubricate Engine Rotors on a stored FD ?
Just wanted to know if anyone knew of an easy way to lubricate the engine rotors on a 93 FD after its been sleeping for while ? I should mention the motor is complete (not apart). I've heard of going through the leading spark plug holes , but thats a little difficult and would like to get two sides lubricated ?
Any help much Appreciated
Any help much Appreciated
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
http://www.aaroncake.net/rx-7/unstore.htm
A few ounces of oil into each leading spark plug hole, rotate the engine by hand, repeat 3 times.
A few ounces of oil into each leading spark plug hole, rotate the engine by hand, repeat 3 times.
Put some fresh cheap oil it in. And after you turn it by hand a few times, I'd pull the EGI fuse and crank it until I saw oil pressure. Replace the fuse and after it starts and gets to full operating temp a few times, change the oil again.
I'd throw in some GOOD fuel system cleaner and flush the cooling system asap too.
I'd throw in some GOOD fuel system cleaner and flush the cooling system asap too.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
stickmantijuana
MoTeC
5
Sep 10, 2015 07:58 PM