Diff cradle in hydraulic press
#1
Junior Member
Thread Starter
Join Date: Jan 2012
Location: australia
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Diff cradle in hydraulic press
Anyone have any pics of how they rigged up their diff cradle in a hydraulic press? Having real trouble doing it and removing the bushes.
#3
Junior Member
Thread Starter
Join Date: Jan 2012
Location: australia
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
I sorted it all out
I used the setup as per this thread https://www.rx7club.com/3rd-generation-specific-1993-2002-16/diff-bushing-install-645194/
I got the plumbers at work to cut me a short piece of 62mm outer diameter steel pipe which i used for pushing the actual bush out and i bought a 65mm high pressure PVC pipe to press against the actual cradle. I was a bit sceptic about using PVC but it held up and couldnt have worked any easier and best part cost me nothing and i didnt have to buy a massive socket that i would never use again for any other reason
I used the setup as per this thread https://www.rx7club.com/3rd-generation-specific-1993-2002-16/diff-bushing-install-645194/
I got the plumbers at work to cut me a short piece of 62mm outer diameter steel pipe which i used for pushing the actual bush out and i bought a 65mm high pressure PVC pipe to press against the actual cradle. I was a bit sceptic about using PVC but it held up and couldnt have worked any easier and best part cost me nothing and i didnt have to buy a massive socket that i would never use again for any other reason
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM