coolant level sensor HELP!
11-28-08, 08:55 PM
#1
Full Member
Thread Starter
Join Date: Nov 2008
Location: poulsbo
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
coolant level sensor HELP!
i was undoing the coolant level sensor when i was taking out my radiator and didnt undo the bullet connector. The wire broke right at the "bolt" of the sensor, not even enough left to sawder, does anyone know if a new sensor would come with some wire attached to connect back into the bullet connector????-thanks noel
11-28-08, 11:02 PM
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Yes it will,and If you are Frugal(cheap) you can find one used in the Ever faithful Sec Gen Parts section.(sender is compatible for 1st and 2nd Gens).
11-29-08, 10:33 PM
#4
Full Member
Thread Starter
Join Date: Nov 2008
Location: poulsbo
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
thanks guys.....appricate it. i found them on mazdatrix but i think ima see what the dealer is asking, see if i can get it in sooner and be back behind the wheel of the rex im getting withdrawls haha.
12-04-08, 04:07 PM
#5
Newbie
Join Date: Oct 2008
Location: Washington
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
The same thing happened to mine- Annoying sound. haha.
I ghetto rigged a wire into where the sensor connects and clipped it to some metal- it grounds it and stops the noise but it obviously doesn't sense coolant level anymore, so I check the coolant all the time, and I definetly need a new part-- But I have to drive the car, so it had to be done.
I ghetto rigged a wire into where the sensor connects and clipped it to some metal- it grounds it and stops the noise but it obviously doesn't sense coolant level anymore, so I check the coolant all the time, and I definetly need a new part-- But I have to drive the car, so it had to be done.
Thread
Thread Starter
Forum
Replies
Last Post