Coolant Buzzer/light at certain RPMs
#1
Member New
Thread Starter
Join Date: May 2010
Location: Plano, Texas
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Coolant Buzzer/light at certain RPMs
my add coolant buzzer/light has been turning on at around 3K rpm and turns off around 4-4.5k rpm. it doesn't overheat. (although one time the temp needle did creep up a little but quickly went back down).
I've searched, but I've either been searching for the wrong things or i missed the topics.
but i was wondering if there was a certain problem that could cause this.
sorry for the lack of info, cant think of anything else to say.
any help is appreciated.
I've searched, but I've either been searching for the wrong things or i missed the topics.
but i was wondering if there was a certain problem that could cause this.
sorry for the lack of info, cant think of anything else to say.
any help is appreciated.
#5
Member New
Thread Starter
Join Date: May 2010
Location: Plano, Texas
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
sorry for double post, took to long to edit.
ive tried running the car while cold with the heater on full blast but my car does this thing that it probably shouldnt. which causes the coolant to surge out with every RPM drop.
video of the rpm rise and fall.
http://www.youtube.com/watch?v=ue-mVHqVzOE
ive tried running the car while cold with the heater on full blast but my car does this thing that it probably shouldnt. which causes the coolant to surge out with every RPM drop.
video of the rpm rise and fall.
http://www.youtube.com/watch?v=ue-mVHqVzOE
Trending Topics
#9
Member New
Thread Starter
Join Date: May 2010
Location: Plano, Texas
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
all that ive been able to find is to fill neck till its full while car is cold. then turn it on with heater on high and fill as necessary, but i cant because once it reaches a certain temp it starts to fluctuate causing the coolant to surge out of the neck and spill everywhere.
also, it only fluctuates during warm up.
#10
Moderator
iTrader: (1)
all my searches bring up how to bleed a s4, which has all sorts of shenanigans meant to bleed it. the S5 is just the filler neck, and that is it.
all that ive been able to find is to fill neck till its full while car is cold. then turn it on with heater on high and fill as necessary, but i cant because once it reaches a certain temp it starts to fluctuate causing the coolant to surge out of the neck and spill everywhere.
also, it only fluctuates during warm up.
all that ive been able to find is to fill neck till its full while car is cold. then turn it on with heater on high and fill as necessary, but i cant because once it reaches a certain temp it starts to fluctuate causing the coolant to surge out of the neck and spill everywhere.
also, it only fluctuates during warm up.
#12
Mike. The big stinky.
iTrader: (1)
Join Date: Nov 2010
Location: ORLANDO FL. WHAT
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Hey buddy. It bleeds me to read this! On th front of th radiator there is a single wire connected to a wire that acts as a ground.If th water doesn't hit it the DARN buzzer goes off! Fill it from the top w theengine running. Let it cool all the way down then open the top let it gurgle turn it on and fill again. Shut it off crack the bottom one and see if the botom is empty fill it. when you do that it will stop when the ground hits water. Fill the resi tank and the buzz will stop. I found when I hit left it stopped or high rpm's when the water pump was screaming. Then i found leaks.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM