Carbonetics Clutch installations problems
#1
Junior Member
Thread Starter
Carbonetics Clutch installations problems
Hello ,
I bought a Carbon clutch pro spec Single of carbonetics a few years ago . Now I have problems with mounting. The manual is for an evo but not for my RX7 FD3S .
The clutch is a pull to push conversion . Now I have two rings, I do not know if I they should install under the pressureplate or not,because the original bolts are too short.(See picture)
I hope you can help me.
[IMG][/IMG]
Jürgen Forke
I bought a Carbon clutch pro spec Single of carbonetics a few years ago . Now I have problems with mounting. The manual is for an evo but not for my RX7 FD3S .
The clutch is a pull to push conversion . Now I have two rings, I do not know if I they should install under the pressureplate or not,because the original bolts are too short.(See picture)
I hope you can help me.
[IMG][/IMG]
Jürgen Forke
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM