Battery relocation
#1
Rotary Head
Thread Starter
Join Date: Dec 2005
Location: Independence, MO
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Battery relocation
So what is the best location in the second gen FC to relocate the battery? Also I have seen several people on here have what looks like a fuse switch next to their batteries, what brand is everyone using?
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
If you don't want it to be seen then you can go to the Passenger bin.It distributes weight off the front Driver's side where the old battery and 20 pounds of windshield wiper fluid stay..lol!
I use an Optima Yellow top.You can get battery holders specific for that battery on Ebay.
You can find a lot of info on Relocation in the Sec Gen Specific section.
I use an Optima Yellow top.You can get battery holders specific for that battery on Ebay.
You can find a lot of info on Relocation in the Sec Gen Specific section.
#4
Hey...Cut it out!
iTrader: (4)
Fabbed the box myself, using Aaron Cake's setup as a model, but adjusted to fit the larger battery and bolt into existing holes. It's a good project to teach yourself how to weld. Mine needed no trimming of the lid or 'flange' and is completely reversible with no fuss.
If I need to use a stock size battery, a spacer made out of 2" square tube can be put in the box to take up the extra space.
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
My 6x9 speakers sit in my bin lids and woulkdn't allow me to Put my battery in unless I "came up with somethin'."
I made a frame of 2 inch and covered the whole top bin frame with 1/2 inch plywood,cut the holes for the bins and slipped them back in.
It clears now.
Here is a Teaser pic.,..I have a build thread going and toss up the odd pic every now and again.
I made a frame of 2 inch and covered the whole top bin frame with 1/2 inch plywood,cut the holes for the bins and slipped them back in.
It clears now.
Here is a Teaser pic.,..I have a build thread going and toss up the odd pic every now and again.
Thread
Thread Starter
Forum
Replies
Last Post
Gen2n3
2nd Generation Specific (1986-1992)
14
08-02-16 10:06 AM
Thecoolguy
New Member RX-7 Technical
4
07-24-16 09:49 AM