After hearing about wiring problems with auto to manual conversions, I decided to replace ring, dash, engine, and starter harnesses with used ones, and got a used manual ecu that was reported to be good. I used the existing cluster and cpu 2. Homes were found for all connectors with the exception of a short pigtail on the dash harness on the passenger side. The white connectors on this pigtail will plug into each other. After installing the harnesses, dash, clutch, tranny, and starter, the engine turns over but their is no gas or spark. The cluster does nothing. The only things that work are the lights and wipers. Any help would be appreciated!