apex seal trouble?
apex seal trouble?
I just bought my first rx7 a week ago and I am wondering if it would be cheaper to just buy a new motor rather than rebuild or if I am wrong about what is wrong with the car.
I personally think that the engine has a cracked block, because when i started the car for the first time it spued water out of the exhaust. It also on the drive home over heated and lost a whole 2 gallons of water with in 2 miles. It is also had foul spark plugs. These are aall signs of a cracked block right?
I personally think that the engine has a cracked block, because when i started the car for the first time it spued water out of the exhaust. It also on the drive home over heated and lost a whole 2 gallons of water with in 2 miles. It is also had foul spark plugs. These are aall signs of a cracked block right?
You would have to rebuild the engine to fix either problem, and if the jacket has cracked, you could be looking at replacing housings/irons too. If the engine is allowed to sit with water in the combustion chambers, you'll end up with rusted rotors and housings (junk). Full rebuild kits are in the $1k+ range, and labor can be $2k+.
Atkins kits : http://www.atkinsrotary.com/index.php?pag=5
Atkins rebuilds: http://www.atkinsrotary.com/index.php?pag=9
Used replacements can be a cheaper option, but most will have high mileage & not really be a long term solution.
Atkins kits : http://www.atkinsrotary.com/index.php?pag=5
Atkins rebuilds: http://www.atkinsrotary.com/index.php?pag=9
Used replacements can be a cheaper option, but most will have high mileage & not really be a long term solution.
Trending Topics
Read this thread. It might be a $4.00 option for you...
https://www.rx7club.com//showthread.php?t=930506
.
https://www.rx7club.com//showthread.php?t=930506
.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Red-Dragon_Akuma
New Member RX-7 Technical
11
Sep 28, 2015 06:09 AM



