'93 FD3S Help
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Jan 2011
Location: Japan
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
'93 FD3S Help
Hello all, today I was driving home from work and I stopped at a stop sign, waited for a bit started to release my clutch and all of of sudden something popped and my car died. I started it....barely ran and it was sputtering and now I can't get it started. It has a 123000 kilometers on it, I've kept up on maintanence on this car, and have no idea what happened. This is my first 7 and just know a little bit about them but not a whole lot when it comes to problems and troubleshooting. I am in need of help. Thank you for your time.
#2
Urban Combat Vet
iTrader: (16)
Open the hood and on the firewall just aft of the throttle-body you should see a black sensor mounted with an electrical connector on one end and labeled "sensor boost". There also should be a single vacuum line running to the sensor from a vacuum port on the driver's side of the upper intake manifold. Make sure that vacuum line is attached at both ends.
If that doesn't make any difference I also recommend a simple compression check on both rotors. Look for three equal pulses on each rotor hopefully reaching at least 6.5 bar or so.
If that doesn't make any difference I also recommend a simple compression check on both rotors. Look for three equal pulses on each rotor hopefully reaching at least 6.5 bar or so.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM