'87 rx7 car's rpm unstable, sluggish,stalls
Thread Starter
Can Post Only in New Member Section
Joined: Apr 2013
Posts: 2
Likes: 0
From: yonkers, ny
'87 rx7 car's rpm unstable, sluggish,stalls
My 1987 mazda rx7, doesn't drive normally after I start it. The rpm fluctuates, the car loses power, stalls and even stops. When I attempt to restart it, sometimes it'll drive for a bit, then it acts up again. At times when it is running, I have the pedal to the floor and the car barely moves. Any answers? Thanks
Anthony-Yonkers, NY
Anthony-Yonkers, NY
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
Fuel filter most likely.
There is a sock on the pump in the tank and another main fuel filter on the frame rail below your feet under the driver's side.(rough area).You need to get under the car to change that.
the tank,you can access by pulling the back carpet up,there is an access to get to the sender/pump assembly on top of the tank.Good luck with the Screws.They are a pain.
There is a sock on the pump in the tank and another main fuel filter on the frame rail below your feet under the driver's side.(rough area).You need to get under the car to change that.
the tank,you can access by pulling the back carpet up,there is an access to get to the sender/pump assembly on top of the tank.Good luck with the Screws.They are a pain.
Thread Starter
Can Post Only in New Member Section
Joined: Apr 2013
Posts: 2
Likes: 0
From: yonkers, ny
thanks
Fuel filter most likely.
There is a sock on the pump in the tank and another main fuel filter on the frame rail below your feet under the driver's side.(rough area).You need to get under the car to change that.
the tank,you can access by pulling the back carpet up,there is an access to get to the sender/pump assembly on top of the tank.Good luck with the Screws.They are a pain.
There is a sock on the pump in the tank and another main fuel filter on the frame rail below your feet under the driver's side.(rough area).You need to get under the car to change that.
the tank,you can access by pulling the back carpet up,there is an access to get to the sender/pump assembly on top of the tank.Good luck with the Screws.They are a pain.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
Haltech Forum
11
Mar 11, 2019 05:34 PM
rkhanso
2nd Generation Specific (1986-1992)
1
Aug 13, 2015 11:40 AM
