86 FC When tach works buzzer sounds
#1
Junior Member
Thread Starter
Join Date: Feb 2010
Location: Arizona
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
86 FC When tach works buzzer sounds
I just pulled my FC out from sitting for 4 years. At first the tach didn't work but now it cuts in and out and when it works the buzzer sounds. It registers the right RPM though so I know it's getting signal. I don't know if it's related but when I have the headlights on the double beep alarm goes off like if I had the car off. Also my oil pressure gauge goes all the way up slowly as soon as I start the car. I'm sure if it was really that high there would be engine problems. Any advice would be appreciated.
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Check the condition of the trailing coil connector.
Also, make sure all your grounds are in good shape. The major grounds are listed here:
http://www.aaroncake.net/rx-7/grounding.htm
Also, make sure all your grounds are in good shape. The major grounds are listed here:
http://www.aaroncake.net/rx-7/grounding.htm
#3
Junior Member
Thread Starter
Join Date: Feb 2010
Location: Arizona
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
I got a used dash with cluster and gauges. nice condition. realized it was for a turbo because of the boost gauge instead of a battery gauge. will it still work? can I make it work?
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM